Neldog0

I soak my bag in citric acid overnight. It works great and it rinses out very easily. Keep in mind that citric acid is used in the food...

Your method is spot on to my method also. I have never had any clogs.

Since the controller doesn’t give a clear signal the the pump is on or off, for safety I move the riser valve to off. When I pull my...

With my certification in Fluid Power & over 20 years in the industry, I would highy recommend using a manifold with check valves. This...

I found a very simple way. I move the ball valve on the riser to the off position. Many times the recirculation arm is in the way so my...

Have you checked your water profile? Also, when you start these units they need to be cleaned & rinsed before use. Use citric acid to...

I have used a citric acid soak. This seems to open the pores better than PBW. Also less caustic & less worry about rinsing out the PBW.

I finished my basement, put in a basin sink, pump toilet & finished the space for brewing beer. It works great!!!

Doesn’t matter. I’ve done it both ways with the same result.

If you close the recirculation riser valve when you turn your pump off, this will prevent siphoning back to the pump.

I also bought use a grain bag. It goes into the Gen 4. I tighten the bag around the outside rim of the Gen4. Then I drop the grain tun...

It sounds like you have too much CO2 in you beer. You need to balance the beer. Lowering the PSI will not allow the CO2 to balance to...

I had the same experience. I dropped the use of them. As one reply stated, once you add CO2 to the head space, CO2 under pressure begins...

Assuming you have CO2 & no leaks in you keg, a fail safe way of adding a volume of 2.4 to 2.7 volume of CO2 is to set your temp to 36f &...

I have found that citric acid is a great method to remove any films that collect over time. I have also used it for a substitute for a...