Recent content by Mrmojo

Add a vibrator to the side? Can't take credit for this idea. I think passdown suggested it in a different application.

You're gonna have to automate it, to keep the forum happy. :tank:

Along the same lines, can you pump into the bottom of vessel B or does it need to go "over the top"?

I was poking fun at my first solder job. The closet I got to a right angle is about 89 degrees. The worst being about 75 degrees.

Lmao, sorry wasn't thinking clearly yesterday. My application is for a Sanke, etc. I'm pretty optimistic about it. But if someone cuts the bottom of a carboy out, I want to see pics.

No right angles...

I'm working on it. Create an artificial slope inside the fermenter. Pics to come. Not high on my to do list, so don't hold your breathe.

I see what you did there...:ban:

Put some sort of baffle in it. \ /

How about this guy? No money and no brains... ****Warning repost****

OK, brought the neutral leg from the light over and into #2 and all is well.

Looking at the hand drawing in post #6, what would port #2 used for with the STC1000? Is that a switched leg? I would think a neutral leg would go here. #1 powers the unit but no return leg out. I see it is empty.

I found a rim guy to do mine $20 a keg and no cancer. I tried one. That stuff gets every where.

OK Thank you. Found what I was looking for. I have the freezer part down no problem. Now the fridge side. I don't have an electric thermostat on the fridge side. It uses a mechanical thermostat to mechanically open and close the damper to the freezer. So no wires there. I have a second...

I just started to convert a Frigidaire side by side. I want to make the freezer side a kegerator and the fridge side a fermentor. My question. I have taken apart the control panels but not the back panel. Do I have everything I need to wire the freezer? Any suggestions for wiring? I will...