Recent content by Mrbadgolf

Im frustrated today, Thins were working great i had water flowing though flowmeters. I tuned the pi off, moved it to my keezer and installed on my liquid lines. Now I get no pours showing, logs look good but no pours registering. Any suggestions? I have full logging enabled. FYI nothing changed...

Can you share what you modified on theflo_monitor.py to play sounds. That would be awesome to add, I am still learning and wouldnt know what to modify.

Ordered last night. Thanks for the info.

I have RFID reader ordered. This is going to be the next big feature for me as far as valve. I had to do some work inside my keezer a few weeks ago and as I was shutting the lid to walk away my shirt caught the tap and opened it a bit, I never noticed. about 20 minutes later I hear the sound of...

My thought was to try to figure out how to use Bluetooth le to register a phone to a user so if the phone is in proximity it would read, or even a scanner that you could swipe your phone , but just some ideas I am trying to work through.

I am not using swissflow sensors but some cheap sensors I got from Amazon. Mine has red- VCC(+) Black- GND(-) and yellow output. I connected Red to 5v on uno Black to Gnd and Yellow to the sensors I set up which are 8-10 and then assigned to a tap. Also make sure that you have count per gallon...

Yes I found it and changed it. One thing i did notice is I create a user account. Log in as that user and pour a beer, it shows that the beer was poured but the user is blank and on the logs shows N/A.

@RandR+ I followed your instructions and enabled logging. I am now getting pour information. Next thing is to set up users and try to show pours in Liters vs gallons. Thank you so much for your assistance and everyone else who gave me guidance.

All of the installs have been successful with no errors. It’s only the flow meter . I have set the number of taps correctly. I have set the pin correctly and tried different pins. I have loaded up the Arduino IDE in order to see if I could get any messages or even see the ticks but that doesn’t...

I am going to blow it out again the the morning and install your version. Just hope I can get flowmeters running. Have 4 kegs and no idea how much is left.

I have tried Tober_8thMan and R+R.

Thank you for this unfortunately still unable to get this working. I would be happy to pay someone for assistance. I did not find the lines that you stated in the flowmonitor.py file. I have uninstalled and reinstalled 20 times now. I have used everything from the raspberrypints repo to R+R...

No matter what I do I can not get my flowmeters to recognize. Truthfully I am not been sure that the uno is even being recognized. I? have worked with ths non stop for the lat 3 weeks. Does anyone have a fool proof method/guide to get flowmeters running. I have uninstalled and reinstalled. I...