• Please visit and share your knowledge at our sister communities:
    Cheesemaking Forum Cast Iron Forum Canning Forum Ceramic Grills
    Espresso Forum Hot Pepper Forums Pizza Oven Forums
  • If you have not, please join our official Homebrewing Facebook Group!

    Homebrewing Facebook Group

Recent content by LuckyKid

Brewer's Friend 728
Homebrew Talk

Help Support Homebrew Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. L

    Gearhead Tap Handles

    Thanks!
  2. L

    Gearhead Tap Handles

    To be honest I really like the lettering. It looks "industrial". There is just the small font that is really wounkey. There is a more accurate laser but these were cheap! I was thinking about something clear like lean but I like this.
  3. L

    Gearhead Tap Handles

    I just received my laser cut inserts! They are made from 1.6l miata connecting rods. The inserts are laser cut mild steel. Now its time for a beer! Cheers!
  4. L

    Reccomendation of a Brew-Pub or Brewery in Melbourne

    Hello All, I have a business associate in Melbourne whom I owe a beer. Anyone have a recommendation of an establishment in Melbourne Australia that I can get him a gift card for? Cheers, Lucky
  5. L

    Office water cooler as temp control?

    I've been thinking about a similar concept using hot and cold tap water and dish washer solenoids hooked up to a microcontroller and a PC. There would be a drain tube a dividers to so the water flows properly. Problem is that there is no way a custom solution like this would be cost effective...
  6. L

    My Stirplate... Cheap and Easy Build...

    Just built one! so far so good! I tried to make it with a mosfet from a drill ESC but I couldn't figure out how to wire it. It was working more like an on off switch. One trip to radioshack and we are stirring! The only issue is I have little control for low RPM. I think I need a...
See more
Back
Top