Recent content by jungdahl

I kegged some root beer at 37 degrees 25psi and it was good. I'd get a good pour, good head and tiny bubbles coming off the glass. I noticed the thermostat had been turned down and the temp was about 34. I turned the thermostat back where it was but I get a different pour. Sides of the glass...

You might remember helping me with this. It's when I turned the keg on it's side and it worked I knew the issue was the post/ dip tube/ gasket... whatever, gas was getting in the line. It's when I was cleaning it to return when I notice the crack at the top of the tip tube. That's what I get for...

I bought a new Amcyl keg. I had just started, wanted to keg root beer. I had the exact same problems you have. I fought it, read posts, created posts. During my research I found some mention of problems with the Amcyl posts, I was having similar problems. I also found some mention of quality...

No, blichman did not say what would happen, just that it wasn't designed for the higher psi for soda.

With soda? At what psi?

I purchased a 3 gal AMCYL keg from a local supplier. Looking forward to some root beer. I had nothing but trouble. The ball lock connecters (CMbecker) were hard to get on/off especially on the liquid side. A complaint I've heard from others with Amcyl. The top was hard to get positioned right. I...

What part do I need to replace the regulator shutoff and barb so to use a duotight fitting. I have a Taprite series 3740 regulator. Just cut my finger on the screw clamp. This was the second time and since I'm on blood thinners that's enough. Already have duotight on the liguid rise.

I was told be blichman the quick Carb is not for the pressure needed for soda but also read a review that said it worked. Did you try it?

Wonder if that will fit on a 1/4" barb?

Is there a brand/supplier or type of 3/16 beverage tubing that produces less foam than others. I need it to be available in 40' or more length. It's for high carbonation.

I'm looking at the Perlick 690SS but not sure the creamer would make a diff. Actually not sure it's appropriate for root beer. I sent off an email to Perlick. I assume the diameter and threads per inch are standard on the faucets.

I figured I would need backing on the inside maybe outside as well. Thanks for the tip on not used chrome plated brass. I found this online and the parts list shows chrome plated brass shank https://www.thescrewybrewer.com/2015/11/perlick-630-series-faucet-easy.html?m=1

I found this article. Even had a parts list. https://www.thescrewybrewer.com/2015/11/perlick-630-series-faucet-easy.html?m=1

I like Perlick as well but dont I like the Perlick line of faucets but not sure how to mount to a fridge door.

Thanks for that. I'll give that a try. The more possible I can eliminate the better.