Recent content by JoepH

When you are mashing in, a lot of the flour wil go through the falls bottom. When there is no circulation and the heating is on it wil burn instantly on the bottom. So mash in without heating, then pump a few minutes without heating and after that you start the program ( with heating) This way...

At the start

Shorten the screw by adding a few extra washers at the top.😂

No, everything fits and is nice in place with my 65Lgen4. Contact your supplyer.

The Seargant Sparge Head is no good.ine little piece of grain or ricehuls will block the fout tiny holes in the Sparge Head. A flawed design if uou want to use it while mashing. It only works while sparging. That was not the promise of kegland.

The second option i think. Always shut the recirculation valve first before you kill the pump. Or lift the hose when submerged before killing the pump. Never use the 60% or 80% pump settings when the hose is submerged..

Hello Renaud00, I have also a 65L gen4. Never had a clogged pump. Your recetculation tube has to be above the grainbed all times. When you shut off the pump there will be a suckback and that will clog the pump. I crusch my grains at 1.35 mm. When clogged shut of the pump. Open recirculation...

No, i did not write kegland. I ordered it by ali express and don’t know if warranty call is possible.

Now after 3 brews my sensor of my bluetooth thermometer is failing. It is not that water resistant as i thought. The conection from wire and tip is bad. It leaks and is giving a fals reading. Poor quality.

This way! Home made

Is there a picture available?

Morebeer does not deliver to Europe.😩

i am searching for this nozzle almoust half a year. I heard amazon, ali express but can’t find anything. Do you have a link to the site or page?

Could you upload a picture of your flysparge fitting?