Recent content by jm_maclaren

You can try and replace the drain pump with one with a greater capacity. e.g. BRAND NEW SEAFLO 12V DC 1.1GPM 70 PSI Water Pressure Pump for RV Boat Marine 647336945126 | eBay versus this which is in the zymatic SEAFLO 2.6LPM 0.7GPM 12V 1.2A 20PSI Water Pressure Pump SFDP1-007-020-21...

Just a random thought is the temp probe in the wort which is at the top by the rotating arm fully inserted.

Mike any update on your ss step filter?

Interested but would you ship? I’m In central pa

I had lots of issues with leaking around the white cap the back. Whenever there was a pool Uber it it was leaking from there. In the end I was able to wrap the threads with Teflon take and that seemed to seal it up.

Interested

Thanks. I was able to lube and put it back together and it seems fine. I used the test stepper position and seemed to let water through the step filter holes ok. I look forward to hearing more about the SS stepfilter

Mike I have found your post on the leak at the stepper arm and taken it apart. There are two silicone bits of tube or washers that seem to fit over the smaller tube that goes into the arm that distributes the wort through the stepper arm. Do both of these have to fit into the larger tube? If...

Mike do you have instructions or guidance for lubricating the stepper arm/motor as part of routine maintenance. Thanks James

Sent you a message, would like to buy

Is it still for sale?

In pa. Would like to buy. Can I do PayPal. Willing to do the up charge PayPal charges and any postage cost on top of the 100

Is it still for sale?

What is the ID/OD of silicone tubing needed to install glycol reservoir recommended from amazon. Thanks

Did anyone notice a blue tint to the water after the PBW deep clean? Hope it's not something to worry about. This must be some copper salt created. It appeared after about half way through the process. From what I've read that can happen with PBW and copper. After the citric acid rinse I'll...