Recent content by JimmySpeakaz

Just a heads up I just looked and compared the ones on morebeer and the proflow. From what I've read the ball bearings on the morebeer female ends tend to stick due to the sugars in the wort. the female is 15 bucks each and the male is 10. I needed 7 of each and it was going to be about 175...

I'm not sure if my way is easier or not but, I basically set three things. outy, cool/heat and target temp. I set to cool and set outy to 3 and the desired temp and I'm off. I tested it this weekend with an old fridge I got for free and about 3 gallons of water and I was able to hold it at...

Not sure if you ever found the answer to this but I also have the jld612 and I accidentally found a setting in the outy that is not in the manual or anywhere on the web. Set outy to '3'. It will be just on and off. Hope that helps.