Recent content by jimmyb33

I didn't use treated on mine. Just put plenty of poly on the inside and out.

Check out my other post on the keezer lid answer. I have some pics on how I hinged the lid and collar. I have a 7" collar and open it up for loading. If you have beer, then you have friends! I got a buddy to help me lift the 1/2 barrel of Newcastle in there last week. Not too bad. It would be a...

It's a 12 volt computer fan. It runs constantly to circulate the cold air. I had problems with CO2 falling out of suspension in the beer lines causing foaming. This did the trick. I wired it to an old cell phone charger with ajustable voltage to control fan speed. I think I have it at 7.5 volts.

No bubble here, just didn't see anyone with this solution on my searches.

Give this site a look. http://www.micromatic.com/beer-questions/sizes-keg-draft-beer-available-aid-11.html Cut out some circles the size of the kegs you think you'll be using and see if they fit in the freezer before you buy it. My guess is the 7cu/ft is too small for a 1/2 barrel. Mine...

So after much research on this forum, my keezer is born. All of my build came from ideas I got from here, except one, so I thought I'd share. Should I hinge the lid off the collar for ease of daily opening, or hinge the collar and fix the lid for ease of keg loading and maintenance? My...

Yes, this is post regulator. So I would have a hose with a QD attached to my regulator, and a ball lock post on my manifold. I was hoping someone had done it and have a part list.

I want to add a ball lock post to my keezer's CO2 manifold inlet so that I can quickly disconnect my co2 tank and regulator. I have read that air line disconnects are not the way to go, and if I use the post and disconnect, I can use the tank to seal kegs outside the keezer. Anyone done this? I...