I second the isolate. I got 1 gram of powder for $15. Half gram in 10 gallons is around 5mg/12 oz (if my math is right). Recommended dose for CBD is 5-10mg.
Project box was found on Amazon here.
I just wired the temp sensors directly to a terminal. The pass-through is a cable gland - one for the grounded power and the other for 3 temp sensors and the usb cable to power the esp board.
It's not as clean as a 3d printed enclosure but it's definitely an upgrade.
IMG_20190112_081846747 by Jeff VoVillia posted Jan 12, 2019 at 10:49 AMIMG_20190112_081811220 by Jeff VoVillia posted Jan 12, 2019 at 10:49 AMIMG_20190112_081742002 by Jeff VoVillia posted Jan 12, 2019 at 10:49...
Hey @Thorrak
Any way to get the last values to stay in the legend box to the right of the graph after a refresh without moving the mouse?
Basically I've got a display that cycles between my taplist and the Fermentrack graph. However, when it refreshes, the graph updates but the values...
I just ended up restarting everything on a Raspbian Stretch setup and it works great!
**Edit**
Not working great. I'm not getting updates on the TILT and signal strength is reading 0. I did a sudo hcitool lescan and it came up with lots of results but none said "TILT".
TILT is reading great on...
Trying to get my fermentrack connected to TILT bluetooth. I followed directions but am getting this error.
arm-linux-gnueabihf-gcc -pthread -DNDEBUG -g -fwrapv -O2 -Wall -Wstrict-prototypes -g -fstack-protector-strong -Wformat -Werror=format-security -D_FORTIFY_SOURCE=2 -fPIC -I./port3...
Great work Thorrak. I switched from an arduino pi0w setup to an esp12e (nodemcu) setup that connects to fermentrack on a pi3 that was already running kodi in my living room. I simply replaced my old setup and it works and looks great!
I've just ordered the enclosure (standard electronic box)...