Recent content by jaybone454

I just bought one for my electric build. Seems like a good deal. Just sharing. Siemens QF250 50-Amp 2 Pole 240-Volt Ground Fault Circuit Interrupter https://www.amazon.com/dp/B00002N7KN/?tag=skimlinks_replacement-20

Just curious if any one is using a banquet table for an electric brew stand. Id like my stand to not be dedicated to brewing and easily put away like the rest of my equipment. I will be brewing in my garage. I just found a decent table on CL for $25. I may just buy it anyway but id like some...

Hey guys. I got the new part from McMaster and everything worked out beautifully. Turned the coupler down to fit perfectly on my Bridgeport. Since i don't have a lathe i had to improvise. Also a picture of my back gassing rig.

Update. Sold.

Got it. After digging though mcmaster carr this morning i think i found what i need. http://www.mcmaster.com/#45525k564/=114d3l1 Od is 1.12. Ill have to update this when i get the part and finish the welding

Jd-I need female couplings. Not too sure i understand you. I have all male 1/2 npt fittings which interface with the keg wall. From what i see the reducers you listed all have a different ID pipe thread which will not work.

Guys thanks for all of the comments and suggestions. A lot of great ideas. Anyway, i a 3/4 reducer isn't going to work because my 3pcs ball valve and swage locks are all 1/2 npt. Ben58- this is what im looking for. I can have that fitting turned down to size and i wouldn't be noticeable. Do...

This is how they have been coming out and im pretty happy until i drilled the hole too big. The tighter the fit to the hole the bet the weld comes out. http://s2.postimg.org/5kb0k9pe1/20160211_200757.jpg

I could but im trying to keep it as clean and perfect as possible. Its a polished keg eherms system. Hopefully the last brew rig i build and would like to do it right one time.

Hey guy. Hopefully someone can help. Looking for a place to buy large OD 1/2 couplings. Like 1.125 OD. Long story short but i am welding fittings in my keggle and my step bit got away from me. With an oversized hole (1.090) my current couplings (.950) won't weld up nice. So id like to buy a...

I agree. But from the search i have done it seems like many have had sucess. The one post which kinda stands out is post 6 in the link below. https://www.homebrewtalk.com/showthread.php?t=509092 Anyway all of the info i have found seems like it was used with propane or direct fire. I guess...

Hello all. Long time observer and 1st time poster. Any way, as the title says, I'm trying to get some feedback on anyone who might be using the norcal brewing level 3 false bottom combo with an electric element. I purchased an ultimate keggle kit from Jay a few months back who by the way is...

Yes its still sitting in my garage. I just emailed you. Ill go get a shipping quote this weekend.

Yes it is

Yea. I was going to build the rolling tool. There is a thread on here somewhere on how to do it. But basically i think it's more trouble than its worth. If i had a buddy to split it with it would be a different story. Anyway it's available.