Recent content by jawbox

Has anyone used the brewpi to replace the ranco controller on a morebeer heated/cooled conical? Where would you recommend sensor placement for the ambient temp?

Finally finished wiring this guy up. Will do a water test this week.

PJ, I'm looking to make a portable rims tube setup similar to this and was wondering how would you change this if you were using the LED switches (similar to GCX3253-120L) from Automation Direct? I'm assuming that you would need to incorporate a contactor somehow for switch 1. Thanks, Jaw

How are you attaching the bcs and contactor to the din rail?

would this one work? Looks like i would be real close to pulling 40A so a little nervous about the 40A form auber.

Ed, What Contactor did you use?? Thanks, Jaw

Ed, Couple of questions for you. 1) Looking at Automation Direct I see multiple curve breakers, Which Curve breakers are you using for the following on your diagram? a) Fast acting (B, C, D)? b) Delay (B, C, D)? Single Pole Double Pole 2) Is this the right switch for...

Which STC valves are you using, and where did you get them?

I wouldn't recommend using a jumper. I believe those terminals are for one wire only. You might be better to splice and run a pigtail to terminal 10. Hope you can see the picture ok.