Recent content by Jaguar77

I meant that I'll have to transfer the contents of one sixtel to a corny so I can get 2 kegs of commerical beer in there.

I doubt I'll try to get a 1/4 in there. I'll probably stick with the sixth and corney setup. Still kinda suckss that I'll have to keg jump into the corny but at least I know it can be done.

Just a couple of quick pics to show how I hacked this beast apart to get a 1/6 and corny to both fit in there, as I mentioned a few posts above. Left side gets the sixtel, the right side gets the corny. First keg comes today. Rise Up Stout from Evolution Brewery in Delmar DE. Good stuff!

I was disappointed in this as well as this is exactly what I wanted to use it for. Not hard to get it to work though. A 1/6 and corny (the 8.5" one anyway) will fit with a little alteration. I used my Fein tool and cut out the sides where the freezer was. Scraped some of the foam out so it...

Thanks for the pic. I'm still not to sure what to do with the wire that is tethered to the thermostat. (The one that actually senses the temp) It goes into the side panel in the very front of where the thermostat is mounted so I couldn't' just flip the whole unit around. I pulled the wire out...

I manged to mess up my thermostat a little bit. Any chance anyone could help me out. I managed to pull off the blue wire, and there are 2 posts that it could go to. One is a short post that matches the other 3 where wires are hooked up. (I assume its this one) There is another post though, a...

After reading 31 pages, I don't think I saw anyone that could fit 2 commercial sixtels in this beat.. Did I miss something or can this absolutely not be done, even with door modifications? Thanks