Recent content by j.funkie

Yup. I copy and paste the full custom stream url on brewfather into the "Logging URL" and select my brewpi device and click "Add Push Target". I've also just used cURL from the RPI directly to post to the brewfather URL. It shows up almost immediately on Brewfather.

I just booted up a Raspberry Pi with a fresh install of Raspbian. Following that, I installed using: curl -L install.fermentrack.com | sudo bash My push still doesnt appear on Brewfather. I'm seriously puzzled..

I'm on the dev branch but have also tried the master branch. it's a docker install inside a debian vm. To keep it simple, i had just used the curl command in the documents.

Hello! Was trying to setup the push from Fermentrack to Brewfather. So far no success. Not exactly sure where to start to look for the problem. Here's what I have and what I've tried so far: - Fermentrack is installed on a Debian VM inside Proxmox. - From the CLI, i'm able to resolve...

Actually, looking further it looks a little weird on the controller logging it looks like this: and lookin at the graph plotted by the iSpindle gravity sensor, i have this: While no data is recorded in the controller side, there is data in the gravity sensor part records.

Hello everyone, on my first brew using fermentrack. Not sure if this has been asked before (i did try to look for it to no avail), but how does one go about deleting a single point of data? Looks like an error in the gravity reading from an iSpindel. With that there, the scaled of the gravity...