Recent content by ih8lag

Just throwing this out there.... Had a brew session last week and noticed this again. That my ds18b20 sensors were off by about 15 deg F. This is a fair amount. These are bare sensors inserted into thermowells 3-6 inches deep. Its not just 1 sensor doing it but both I have in my system. I...

Worng Forum.

Brewed this up last night for the 2014 edition I made a few recipe changes because I have switched from a batch sparge set-up to a recirculating no sparge set-up so the grain bill had to change. I adjusted the Grain bill to be 12.25lbs of 2-row 1lbs crystal 60 1lbs victory 2 large cans of E.D...

An FTSS would be awesome to go with my SS BrewBucket

Brewing this again this year it was tasty and looking forward to this years. Ran into stuck sparge last year. I cannot remember if I used rice hulls or not. I cant get them this year everyone seems to be sold out. So what if I put the pumpkin in a muslin bag and mashed like that or even mash...

Looking good Doug... Not sure if this version has introduced some new issues on the controller GUI. I was tuning in the PID last night and the controller page was not updating with duty cycle/temp... I ended up using the live data graph and getstatus to get current temp... There was also a...

Yeah had his IPA when he first opened 5 months ago or so. It was not bad considering i am not a huge IPA fan.

Much better Doug still one issue on the RaspberryPi. Once the PID hits temp i get the following. Then I have to shutdown and restart before i can do anything else. Cant wait to get version 2.0 of the e-brewery running my hiatus of 5 months has been too long.

Hi Doug... Getting out of bounds exception on a raspberry pi latest version... I even posted the issue on the Git site for you with console logs get status capture and config file.

Thanks for the reply... Have not really decided on the hops yet. That will more rely on what is available at the brew shop :) I know they stock cascade and a few other north american hops...

Not a big fan of IPAs but have a whole lot of loose stuff kicking around that I am trying to use up. So I am considering doing a Cream Ale IPA? Here is the grain bill 8 lbs Pale Malt (2 Row) US 1 lbs Corn, Flaked 4.0 oz Caramel/Crystal Malt - 80L 4.0 oz Carared 6.00 oz Chinook Boil...

I have to ask how are you doing the volume measurement?

First batch all electrinc in progress a nice light canadian cream ale... Boil will be done right before Walking Dead time... No complaints at all this is actually saving me about 1-2 hours on my typical brew day :) I just need to engineer a better exhaust system and add a few pumps to eliminate...

From my experience with the config wizard you do the following pick sensor number give it a name then gpio number i.e GPIO11 if you only have the one sensor setup just type quit then it creates the new file rpibrew.cfg.new config file for you then you can do a "cat rpibrew.cfg.new > rpibrew.cfg"

Looks good. No more Java errors. Was going to brew on the Holiday yesterday but was overloaded on turkey and pumpkin. Going to try for this weekend.