Recent content by ifpthenq

In a moment of stupidity, I pitched my yeast starter into a 90° must. Immediately after, I put my fermentation vessel into a 60° bath of water and have been letting the temp get down to proper fermentation temp. Will this adveresely affect my yeast or should I be ok? I know better, but I was...

I've heard a lot of good stuff about these gizmos. My drill is waiting.

That was pretty much my thinking on the whole thing. I didn't want my smallest diameter to be at the source, which is a whole 1/8" smaller than everything else (yep, because of the wall thickness). $23 per pickup tube is a little expensive to use them for a while and then change your setup...

So, I'm finalizing my keggles and ordered what I thought would be 1/2" ID pickup tubes from BargainFittings. Turns out, they're 1/2" OD. I was trying to achieve 1/2" ID throughout my single tier brewstand, including all valves, tubing, and pickup tubes in order to have the same flow rate through...

Hey everyone! My all grain setup is slowly coming into its final stages and I'm so excited! Without you guys and your extensive knowledge of all things beer, this would not be happening. Any questions I have had, I've been able to find the answers on here, and, for that, I'm eternally grateful...