Recent content by Heide264

Yup! Just whenever they fill up ya put the order in... and so it goes.

Not too bad for me. I'd probably rather drive an hour to Washington than fight through the south side... I'm a spoiled suburb driver with a stick shift, haha. Do you plan on keeping the 'rolling batch' idea?

Did you mean "All temp sensors in a BSP tee" or did you actually mean flow? Those one wire temp sensors are slick. I like them a lot for the brewpi. I would really try to make an easier calibration algorithm for them though. I keep meaning to calibrate my brewpi sensors... but then I never do...

I don't want to hijack the thread by any means, but I guess it is pertinent information to any HERMS system. If you want to edit this stuff out El, go ahead and go for it. My mash thickness becomes a mute point in terms of flow restriction. After a few minutes the grain is in the bottom of...

Hey. I was just wondering if you still needed me to follow up with this? I had to redo my setup to incorporate a 2nd brewpi server. Do you still need more info?

Thanks. I actually do preheat my false bottom and coil with the strike water. It does help. I use a 25' 1/2" copper coil for my heat exchanger - it comes out within a degree of the HTL temp I believe, regardless of flow rate. I'll double check next brew. I think the basic issue is that you...

Just my $0.02 on the lines. To each their own. I was pretty bummed to see the build up in my various plumbing fittings though over time. It is nice to be able to squeeze a bit and judge flow. Check out Omega for flow sensor ideas (and way more info than most people would want)...

I admittedly did not read through the entire thread in detail, but I have some input - sorry if it has already been said. For what it is worth - I use a brewpi setup on both a fermentation fridge and chest freezer... It's awesome. My HERMS system does not play nicely with an Auberins PIDs as...

Had the same issue a few pages back: https://www.homebrewtalk.com/f51/howto-make-brewpi-fermentation-controller-cheap-466106/index191.html#post6395052

I still think some of the 2x quantity splits are a bit goofed up. I have 2x of the BM Munich malt splits, for example.

Just leave the split at 25% and select a quantity of 2.... 2/4 instead of 1/2 =)

Good morning! I recently got this ordeal setup pretty nicely. I'm happy with it - I just want to add some more insulation to the fridge and add a small PC fan in there. Anyhow, being fully aware of the security concerns, I did want to open my Brewpi to the web, at least for a while, to keep an...