Recent content by Guper

I think I PM'd you, but I'm not sure because it's "start a conversation" rather than send a message, but I'm assuming that's equivalent for HBT.

No worries! Here's the info you asked for: " Rebuilding app Authentication and Authorization... Rebuilding model <class 'django.contrib.auth.models.Permission'> - FK Check Disabled: True Rebuilding model <class 'django.contrib.auth.models.Group_permissions'> - FK Check Disabled: True...

@Thorrak Not sure if you saw this, but still unsure how to get the ability to log back after doing the update.

I went to go turn on my Fermentrack setup to ferment for the first time in a while and couldn't connect to it via anything but SSH because I was getting a bad gateway error if I tried to connect via the web interface. Came on here and was able to successfully use the script that repaired the...

Thank you SO much! Your instructions worked perfectly. Perhaps the instructions within Fermentrack should be changed to match that as well since those were the directions I was following to fix the problem, but wasn't working. Below are the instructions Fermentrack gives:

Also it actually looks like it is failing when doing it under fermentrack (Still can't do it as sudo but can run it without adding sudo) and getting this error: arm-linux-gnueabihf-gcc -pthread -DNDEBUG -g -fwrapv -O2 -Wall -g -fstack-protector-strong -Wformat -Werror=format-security...

I actually already tried that. When I try to run " source ~/venv/bin/activate " from the pi user I get " -bash: /home/pi/venv/bin/activate: No such file or directory "

The URL was essentially " http://##.##.###.##/tiltbridge/ " but the IP address in place of the #'s was not the local IP address for my home network I'm running Buster on a Raspberry Pi 3B+. I've tried following the instructions Fermentrack lists for getting bluetooth support back, but it...

I was having trouble with bluetooth working using Fermentrack on my Raspberry pi so I decided to go with a ESP32-based TiltBridge. I got it flashed and connected to my network but Fermentrack said "Unable to automatically update Fermentrack URL on TiltBridge Tilt Bridge 1" so I manually set...

I would check that your flow meters are wired correctly. The swissflows should be wired so that the wire with the stripe on it goes to a ground pin on the arduino, the middle wire goes to the data pin (I use pins 8, 9, and 10), and the outside wire without the strip goes to 5 volts on the...

Very cool man!! So where/how are you planning to get AC power into the project box? Are you planning on having the Raspberry Pi be separate? Why not mount that inside the case as well? Once you bring in AC power you can just cut an extension cord, wire it into your A/C power and plug your power...

@RandR+ Not sure if you remember, but I had mentioned before that despite answering yes to both disabling screen blanking and that I wanted it to open chromium in kiosk mode it wasn't opening chromium in kiosk mode. I also said that with the workaround I was using by putting an autostart file in...

Oh the joys of 3D printing haha Rapid fire question time: What material are you printing in? What are you planning on using for components? Are you planning on releasing the STEP file so others can make the edits necessary for their specific components?

@muhteeus love the work you're doin! I was looking into doing something exactly like this, but looks like there isn't much of a point now haha Until you get the actual vector file you're looking for here's an SVG I made from the fermentrack logo...

So I've added my tilt and bound it to my Arduino-based temperature controller, but it doesn't seem to be logging any of the data on the graph. Is there a setting I'm missing somewhere to display that info on the graph?