Recent content by Geneween

thanks It was shutting off and my beer was only getting to 55 degrees...

I was wondering if this is the temp sensor for my kegerator. it runs from the temp control knob to behind the chiller plate thing. I was wondering if I moved it closer to the front of the kegerator would it make the whole thing run cooler. thanks g

Would a full load of priming sugar cause over carbonation.

I do/will have/use CO2 but these will not go directly into the fridge for a few weeks there are a few more in front of them that will be forced carbed. So I was going to try to self carb these while they sit. g

I've read online here that you use less when racking into a Corny than you do into bottles. Is this not the case that would be simple. g

you can try to use thin molding from the molding section of the local HW store. You can either use finish nails or glue or both to add a little height to you collar. g

Looking for a Calculator for how much Priming Sugar to put in a Corny Keg... Gene

I have been scrubbing them everyday with hot water and PBW, then a thorough clean water rinse, then they soak with hot water and PBW overnight. Been doing that for the last 5 days. I will switch to Bartenders friend in a few days then do a acid wash followed by one more bartenders friend wash to...

I got a couple of Corny kegs for free that were used for carpet cleaning. Anyone have success removing the cleaning solution and getting it ready for beer. Thanks, Gene