Recent content by FSR402

This system is gone. Sold it to a fellow PrimeTime Brewers member who is opening a brewery near buy. He needed something to get started on until his real system showed up.

I have a Marsh 809 pump mounted inside the plastic tool box sitting in front of the rig. I will not sell the pump unless I sell the other parts first. Would just keep the pump and chiller but added it in to make the deal better for the buyer.

the mashtun is made from a 55 gallon plastic barrel and insulated with water heater blankets and the lid has 2" of foam insulation on it. Sadly the tun does not look all that nice. I covered the insulation with duct tape to protect it from damage. I intended to then wrap it with 1x4 oak boards...

The burner was a SQ-14 burner that many people here use. Only I went crazy with some steel tube and a welder to make it strong as hell and then I added a 2nd burner to it. So it has two SQ-14 burners. I use two of them to get it to a boil in about 30 minutes then I turn one off and run just the...

----SOLD---- I am no longer brewing these large batches so this system is taking up a lot of space. What I have is a 30 gal HLT, 55 gal MLT and a 55 gal kettle and a 35 gal conical fermenter. Price for the whole setup ready to brew is $900. For that price you will get the conical fermenter on...

Pump is sold..

Yes it is. I need to measure the box when I get home tonight so I can get the shipping cost.

Sorry about that. I have not been back here like I should have been.

sold

ok you twisted my arm.. Put me in please.

I use that same one. Works well. I drilled a hole about the 2.5 gal mark for a "weldless" racking port and went with 2" TC butterfly valve for the dump. I then mounted it to a wood platform with 10" wheels so I can roll it from my barn to the front garage when full. For cleaning I use a...

I can tell you right now that the ball valve you have on there will not work. I have a 1.5 valve on one and a 2 inch on the other and they both can plug easily if I wait to long to dump. I would never go smaller then a 1 inch but bigger is better. Oh and no brass, use stainless or plastic.

Do you happen to know what they used that for? To me that looks like a home bio-diesel setup.

old thread but it sounds fantastic.

No you didn't.. He did not bring it because it was all gone. I "heard" that my IIPA took 3rd in the best of show. Wish I could have tried that Alt. :(