Recent content by francoarg1

SSBrew - 728
Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. F

    Problem dispensing - too much foam

    Yes, the calculations would be a bit off, but I don't know the exact roughness. I used the one for vinyl, e=0.000016 [ft]. The beer comes out at around 40F.
  2. F

    Problem dispensing - too much foam

    It has the same inside diameter as the vinyl tubing, 6.8mm or 0.223 inches.
  3. F

    Problem dispensing - too much foam

    between 2,45 and 2,6 volumes CO2. Around 11 PSI at 38F. It depends on the style I serve.
  4. F

    Problem dispensing - too much foam

    Yes, it is a 55ft long stainless steel coil. I have the keg at that temperature when I serve an outdoors event. I store it at 34F, then take it to the event, the keg eventually warms up. The keg sits outside for the event, and i chill it with this diy chiller. Something like in this pic, not my...
  5. F

    Problem dispensing - too much foam

    Hello, this is my first post and sorry if this has been posted before but I couldn’t find a solution. I’m trying to dispense beer from a keg that is at about room temp (65F). I have use the formulas to calculate the line length and I have the correct length, about 60ft., that includes a coil...
See more
Back
Top