Recent content by ellj

I poured a solo cup full of beer. Flow is a little slow, I can increase pressure a bit.

Here's what I see in the rpints.log file: The flow meter is plugged into Pin4 on the Arduino, so am I assuming the "RT L 4" refers to this?

Should I be using /dev/ttyACM0 or /dev/ttyS0 in my config file if connecting to arduino over USB?

Hi, I just added flowmeters + Arduino Uno (what I had laying around) to my raspi via USB. I am running RnR Rpints on a fresh install of the latest version of Pi with flow meters enabled. Flowmeter runs to a bread board with red getting 5v from arduino, black to ground, and yellow to arduino pin...

It is working now

Thanks for looking in to this!

I didn't before. I have redone the install by curl/sudo bash and selecting reinstall and saying Yes to wanting the temp probes but still have same issue. I don't seem to have a /var/log/rpints.log Any recommendations on what to try next?

Hi all, got the RandR version of RaspberryPints up and running. I am nowing adding a temperature probe. The temp probe is connected to the gpio4 and 3.3v and ground pins on the pi (no arduino). I believe I have connected it successfully and I can cat the file from the command line and get...