I personally used the brewflasher that you linked above. I’m not sure if that is what you were suggesting, but it said it wiped and then installed the flash after that.
So, I just tried the wipe then flash and still nothing. I have a couple more boards that I will try also.
Is there a way to flash and test the D1 board before soldering it to the iSpindel?
Hello. Have you found anything to fix this problem? I too have this issue. I built 2 of these and both flash fine, but I cannot connect to them over WIFI. THANKS.
JonW, I have been thinking about your setup and building one like it. I will probably have many questions throughout the project that I will post. Is there any reason to use two valves per pump instead of a three way valve per pump? Thanks for the help.
D.L.
Hello everyone. I have been roaming around HBT for some time getting ideas on what I would like to build. Currently I brew out of two Igloo cooler and a 10 gallon BK over propane. I am moving forward and going to build a all electric brew rig and want to be able to go even further and automate...