Recent content by Easily_Distracted

Done.

I used smaller than 1/2". Maybe 3/8“? You actually don't need a large amount of flow through the chiller. I usually dial the flow back until I start to feel the water come out a little warm. That way I know I am pulling off heat but not just wasting water. I'll adjust the output as the...

In it to win it.

I highly recommend making a simple, copper immersion chiller. I watched a couple of youtube videos until i was comfortable and did it. I just used the lowes 25' copper coil and formed it around a can (I used a scuba tank) and used a small, hand held bender to form the in and out lengths. I also...

Entered.

Done.

+1

Done.

What kind of accidents? Would you not recommend using them as-is? Is the sankey top part plastic or stainless? Thanks and sorry for all the questions.

Again.

Hey, sudbuster. Thanks for the immediate PM. I'm not sure what I did to draw such hatred but it was not meant to offend anybody. Thanks for the warm welcome.

Again.

Done.

Where are you located?