Recent content by DTV

Thanks for the help!

Damn, maybe that was it then! Wish a) I knew what all these values were for and how they work so that b) I could understand the manual better when I read it. :) That must/may be it then. Guess I'll have to try auto-tuning again and not freak out when I see the temperature drop a lot. Thanks so...

Thanks for the reply. Yea, I knew trying to autotune during a mash wasn't the best idea, but I figured it wasn't any worse than my direct-fired RIMs system which was always all over the place on temps. This is what it says on the manual for 2362: 6. Auto-Tuning The Auto-tuning function (also...

There is a setting on the 2362 PID to determine the best parameters to use. I tried running the PID with the out of box settings and it didn't seem to work so I tried "auto-tuning" so that the PID can figure out what the best parameters to use were for my system. From my understanding the PID...

Recently just build a RIMs tube using the "RIMs for Dummies" thread as a guide. 1.5" stainless plumbing from Murray Equipment (10" nipple), 1500w 120v element from Plumbing Supply and the Auberins 2362 w/ 2" RTD probe. All I plan to use the tube for is maintaining my mash temps, and since I...

In no huge rush... if I don't get another 20G before your buddy is ready to sell then I'd definitely be interested. I'll PM you my email.

Looking for a 20g and a 30g Blichmann. Anyone selling?

There's a couple.. one up on Capitol hill, one down by the stadiums on 1st, and one up in Greenlake. Men's Room.. yumm...

Our water loss measurements that I put in BeerSmith due to boil off, trub, dead space, etc. are all pretty spot on. We lose the expected amount of water at each stage. We use a 1.33 quart/lb for our grist/water ratio, and use whatever numbers BeerSmith throws at us based on grain bill for strike...

Me and a couple of buddies are pretty new to brewing, but have read up quite a bit and have done our research. We did 4 extract kits which turned out fairly good, then decided to venture into all-grain a couple of weeks ago. Due to personal preference we are non-plastic, all stainless/metal...

Thanks guys

Looking to buy a Monster Mill 2 from someone. This will be my first mill, but anyway to tell the difference appearance wise between the 2 and 2.0? Does the 2.0 say 2.0 on it?

Really random question, setup a temporary RIMS system last night until my brew rig is built. Used copper tubing and fittings and stainless steel quick disconnects that I had. The quick disconnects were crucial since the plumbing/kettles/etc needed to be portable and movable. Doing this since I...

PM Sent if Fijidave12 doesn't buy it

From the pic it looks like 809-PL-HS-C