Recent content by dsteeves

I just finished building & testing my whirlpool arm. The design is very similar to the one suggested except it accommodates BKs with valves at the top. It does a great job, and to build two dip tubes (one shown here, the other in my HLT) and the whirlpool arm it cost me less than $30 (including...

Hi, I have a ss brewpot as my HLT and I've fashioned my own 50' copper HERMS coil (bent in a 14" diameter). I mounted the HERMS coil to the pot via compression fittings, but the weight of the HERMS coil is bending my pot (the ball valve attached to the lower HERMS port is pointing a bit upwards...

Hi, thanks for reading my thread. I am a new to HBT and am building an all-electric 3-tier HERMS system. I would very much appreciate any feedback/suggestions on my design. I've included the basic schematics for layout, HLT heating/recirc/fill operations, MLT HERMS and sparge operations, BK...