Recent content by Downs

pm sent

I would be interested in the other shanks/tap again if you did decide to break it up.

would keg lube do anything though? its the poppet specifically that isnt working its like its not shutting all the way i would think if it something more to do with the orings maybe keg lube not that i wouldnt try it local brew shop doesnt have keg lube

OK I've searched around and have some ideas to try to fix these things but I think it might be something I'm doing .... So first keg started leaking, noticed it when I lost a tank of gas, was leaking when the quick connect was on, but not when it was off. Finished that keg of beer by...

Springer, Good point, I've gotten by with ratchets, pliers and adjustables until now but it looks like to do things properly i should get some wrenches. thanks

riiight duh i have an adjustable so i actually dont have any wrenchs thats why i havent tried any ill borrow a set and hopefully get that changed out thanks guys

One of my valves is not closing and I have gotten a new poppet for it. However none of the rachets I have tried are "deep" enough to fit over the whole valve and reach the "bolt" if you will where it joins the keg. What can I use to unscrew the poppet valve so I an replace it? Thanks.

i thought it was holding pressure but now im not so sure i had to get the co2 topped up so ill see today that small corny is a coke corny totally not useful with myset up going to see if i can swap it with someone

good point big I'm going to watch that big one and see where exactly the leak is and what is going on

motherfxxker one of my full size cornies seems to be leaking out of the rubber at the bottom? i assume this means that corny is on its way out?

ok so that company doesnt ship to canada displaced so that wont work i wondered if i could just push a pin or something ill have to put some co2 in her and see what happens thanks again fellas great forum here man

ahhh exactly that pin type is like one of my others so are all pin and lock lids the same size I'm assuming

So i just got this smaller corny sort of by accident, expected a 5 and got a 3. My question is how do I bleed pressure off this, all my other bigger ones have either a pull pin or a lever. As you can tell my the pic there is just a valve in the middle of the lid. Hoping i dont need to...

that came off sounding wrong i do get some sediment obviously just not a ton im transporting today and the event isnt until tomorrow so hopefully everything will settle im going to "test" the first pint anyway or maybe a couple so none of the actual guests should get anything but clear...

wow guys thanks for all the great advice i dont have a lot of sediment at all, im real picky when i rack so none of that tends to make it. i think ive got a way to keep them upright so ill try that and only lay down if need be and oh yeah the cool thing about being your own boss i...