Recent content by dogpoundbrewery

How do you like your brew controller

I see you had Alex build your controller . Have you had any other issues with it .

I honestly think the SSR is fried . Alex had a problem with it when he built the controller . He fixed or changed it because it delayed the shipping by a couple days . The noise the controller makes sounds like when a electric pump or motor loses one leg of 110 it stalls and has that humming...

It doesn't power up damn auto correct

That would be great maybe we can set something up for next week going away tomorrow for a little R/R . Just a question on the pids there copies of aubers syl 2364 . I programmed them for the correct temp sensors for use with heating and as SSR pid control and Fahrenheit when I put them into auto...

Yeah fun lol and frustrating . Last year I decided enough was enough lugging water from the house out to the garage during the winter . I welded up a new single tier brew stand for the basement sold my old stand and kettles and started on this great path of an indoor electric brewery . I...

Good luck in your build . I know the feeling of brewing outdoors I'm in buffalo I've set up an indoor brewery no my basement but due to issues with my control panel I'll be doing outdoor garage batch tomorrow before the temps drop below freezing again . My one recommendation is if possible built...

Yeah I played with pids last night thanks auggiedoggy there the same as the aubers . I've been trying to reach Alex for a few days . I'm going to send him an email .

Thanks auggiedoggie I bought this controller last year actually Alex built it for me . It's a 30 amp controller with an interlock switch 2 pids which were supposed to be my pin ta4 's 2 pump switches and a boil kettle control switch .When I switch the interlock switch to the boil kettle the...

How easy is it to set your pid ? I have them in my controller but I never got any paper work for them ! I also have other issues with my controller as well

Thank you jeffmeh its an old dedicated circuit that's not being used anymore but I'm going to wire a spa panel in to be on the safe side anyways . Thanks

After taking everything back apart and checking the panel and wiring I have three wires H-H -N . Is it common not to have s ground ?

I'll check it when I get home tonight . Let's say I'm wrong I certainly could be . If I have H-H-N can I run my controller if I run a ground from the receptacle back to the fuse box ? Thanks for any help guys .

No I have H-H-G it's an old house still has a fuse box . It has an old style dedicated 30 amp breaker for a dryer . I replaced the wire and the receptacle . Guess I'll bite the bullet and have my friend who's a licensed electrician change the fuse panel over to a new box with breakers and a sup...

My new control panel is set up for a 30 amp 4 wire plug . I have a dedicated 30 amp circuit but it is only a three wire . I've been told I could tie the ground and the neutral wire together on the cord from the controller going to the receptacle plug . My questions is I have 2 110 pump switches...