Hello Thorrak,
You have the binaries firmware.bin, spiffs.bin, and partitions.bin. When I compile with PlatformIO it loads into my device, but it doesn't seem to create the .bins. Is there another process to create the bins separately?
Thanks for your help.
DB.
So, my device is connecting to my network. I can see the device in the routers list of connected devices. But I cannot access it by pointing my browser to http://tiltbridge.local or "10.0.0.146".
I disabled my firewall. Enabled the router DMZ for 10.0.0.146. But the browser still reports...
Hey Thorrak,
I was able to complile for ESP32-DevKitC with platformio IDE and I uploaded to the ESP32 from platformio IDE. It seems to work up to the point of accessing the ESP32 using http://tiltbridge.local.
I was able to set up initially with tiltbridgeAP. It appears that it cannot...
Thanks for the info. I'm developing on the ESP32-DevKitC which houses the ESP32-WROOM-32D. Then I will build my own board, to integrate temperature control and tilt on one board using the ESP32-WROOM-32D. Your compiled .bins should load just fine on this board, but I want to add to the code...
Hello Thorrak,
Do you have any info for developers. I would like to compile your project for another board I have. But I don't know what compiler/libraries/setup is needed.
Thank you,
DB.
The point I was trying to make is you dont know what your getting. I think Thorrak even suggeated quality issues. If you buy an Espressif made board from a US supplier, digikey, mouser etc, quality is good and all documentation, schematics, design notes etc. are readily available. With all...
THORRAK,
Since boards purchased from AliExpress are not reliable and and there is a quite a bit frustration getting these boards to work, why not develop the software to be used on a Espressif Development Board such as the ESP32-DevKit3. This board uses the the official ESP32-WROOM-32 and is...