Parting ways with my conical fermenter as am I downsizing my fermentation set up a bit.
It is in very good condition and has treated me well over the years.
It addition to the standard butterfly valve and threaded sample port, it comes with:
Blow off Assembly
6" leg extension...
Here are some pics.
I added aluminum duct tape to the inlet hood joint in order to make it a smoother transition. I also tilted the hood to slope toward the drain to promote condensate running to that location. Going to give it a try again in a week or so and see if any of that helped.
Thanks for feedback all!
There is a lot of condensation in the condensate hood. So much so, that it is dripping off the hood and back into my kettles. I do not have any baffles on my condensate hood, it is a simple stainless steel box with a vent hole at the top.
What I'm wondering is if I...
Thank you for feedback.
I know it is not 100% additive, but do you happen to know how to calculate equivalent CFM of two fans in series with one another?
Also, technically the opening in the hood is the lowest point in the entire system. Is that a bad design?
I poked around the forms a bit and could not find an answer to this question.
I have my electric brewery up and running. On my first brew day, all went well except I am getting a serious amount of condensation in my condensate hood.
The hood is 5' long x 2' wide x 1' tall. It is 2 ft...
I am installing the non-dented hood tomorrow and will take pictures and post to this thread.
A little bit more information I forgot to include: This hood was build by Larkin Hoods (http://www.larkinhoods.com/) It is their standard economy hood that was made to the custom dimensions I...
I realize this post is old, but I'm about to hang my condensate hood and wanted to see if you had any advice.
It looks like you used strut? Did you just bolt that to joists and then hang threaded rod from it?
Dimensions are in title. 5 feet wide by 1 foot high by 2 feet deep is the actual size of the hood. Dimensions including crating materials is closer to 6 feet wide by 2 feet high by 3 feet wide. The shipping weight was listed as 140 lbs.
I'm trying to not get involved with shipping. If you...