Recent content by ddimaria

I kegged a pinot blanc for my wedding party about 8 years ago. It was forced carbonated, somewhere between 20-30psi and served cold at a low psi. It worked out well. I forgot about it in the back of a fridge (34F) and tasted it recently. It held up really well, even improving over the 8...

Thanks for following up guys! I was a bit sloppy in my last post relating to the wiring and the function of the SSR. Good catch BadNewsBrewery, the third wire is a ground, not a neutral. Also, nice correction on modulation. I did a conductivity test on posts 1 & 2 on the SSR when the SSR was...

Yea, my diagram isn't 100% correct. I have a slightly different coil (220v Auberins). It's hooked up properly and activates when turned on, which powers the PID (Auberins SYL-2352). I verified that the PID is sending DC current to the SSR via a multimeter (also, the LED on the SSR lights up)...

Thanks for the reply! The SSRs have the same manufacturer (Fotek), but come from different vendors. They are inexpensive SSRs from China ($13 includes heatsink)...maybe I should have gone with an Auberins or Grainger. Does the wiring look OK to you?

Hello, I'm having an issue where I'm unable to fire my heating element with the simple wiring diagram below. It's a 3-wire, 220v/20a circuit...ground is not shown. When I fire up the system, the PID turns on and is set to manual mode to run at 100% The RTD probe is hooked up as well. The OUT...