Recent content by dave-s

Marvellous, thank you, Matt :)

One last question if I may. Is the pump signal from the pad right next to the probe connector, or is it one of the three pads grouped together behind the probe connector? Thanks Dave

Thanks, Matt, you are right, I had it connected to the 'Cool' relay. I thought that was what you meant by 'unpopulated output'. Will give what you say a try for the next brew.

Hi Matt I've recently installed a flashed STC 1000 with your OVBSC firmware on my Grainfather. It's a great improvement, thanks. However, I wish to control the pump also but an having a problem. I can get the pump to work during SO output fine, but during the Mash steps the PO output is 0...