Recent content by Cthorbr

Thank you everyone for the replies. I'm not sure why I missed/didn't think of a heater with its own safety system. That essential relieves all my worries. A frozen batch would suck for sure. But only for the fact that it's frozen. Thanks again! I'm looking forward to starting this project.

I'm in the early stages of designing a temp controlled fermentation chamber. I'm about 75 percent sure I'm going the brewpi route. But regardless I know I will be using 2 10a SSR's for the heat and cool cycling. One thing I have stumbled across a few times now is the possibility of an SSR...

Thanks for the reply's at least I know that someone makes them. For some reason Home Depot and Lowes don't carry them in Canada but at least with the p/n I can go scouring eBay etc. Thanks

Hi everyone Has anyone ever seen where you can buy just the plug end only for a 4 prong dryer outlet. I am powering my controller from a dryer outlet (inline gfi spa panel as well of course) and I need about a 15ft run of cable from the outlet. I would rather just buy the end and 15ft of...

Thank you Tyler and Doug. That is exactly why I wanted to post this in case I accidentally over looked something like the light to ground. Agreed, that should definitely go to neutral. And Yes I will be using contractors instead of relays. Just forgot to change the label I guess after I...

I have spend the last few months researching and designing my own control panel to suit my brewery needs. I am planning to do a 2 vessel HERM's system with the HEX coil installed in a second lid that I have for my BK. That way I can use it during Mashing/Lautering and sparging and then remove it...