One of the other threads for this was quite larger. There were some larger issues at hand. I ended up just putting a live controller on the entire unit. Terrible inefficient but it gets the job done.
Ah, thanks for the info. What about using a love controller with two outputs wired to the same motorized ball valve. When. It gets to the cool temp it will open the valve, when it gets to the heat temp it will close it. I have one of those and assume it would work better for this scenario, I...
Thanks guys. I'll work on this, I think my doorbell transformer just failed on me. Any suggestions of something to use in its place?
And I agree with the inkbirds, using auber and love controllers for everything else. Just needed some cheap for 24v. Good thing is the motorized ball valve works...
I have a motorized ball valve and a pid I'm trying to get to work together.
Inkbid itc 106
Door bell transformer
3 wire motorized ball valve
Rt-100 probe
Using to take glycol from a loop to a fermentor until it gets to temp and then close the ball valve when it is at temp. I need to power...
I have a motorized ball valve and a pid I'm trying to get to work together.
Inkbid itc 106
Door bell transformer
3 wire motorized ball valve
Rt-100 probe
Using to take glycol from a loop to a fermentor until it gets to temp and then close the ball valve when it is at temp. I need to power...
Hi all, I've been trying to find some helpful info and haven't been successful, maybe someone here can help.
I scored a glycol chiller from a distributor that had a one loaned to a bar and they unfortunately closed down. It's a banner 1/5 hp line chiller with 1 in and out. I'll attach photos...
Having some trouble. Wired and programed my freezer up and the love TS2 just won't cycle the compressor. It randomly turned on for a minute but turned off with out getting the freezer to temp.
I wired into the original thermostat wires. I just connected them and the compressor runs fine, it's...
I would like to build, or buy, a new controller and power source to make a electromagnetic stir plate. The old controller didn't work so I took out a couple of the coil magnets with hopes to make a new one.
I had an electrical engineer at the time that was going to help me but that...