Recent content by crabbit

BrewSwag 728
Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. C

    Can I get a sanity check on this design

    I am moving from a RIMs BIAB to a full eBIAB single vessel system. I have the PID and the SSR etc. from my RIMs setup. Would the voltage regulator in the following drawing work to control the boil and is there another way I could use one of the alarm relays of the PID to fully open the leg of...
  2. C

    Anyone using a Tilt hydrometer with a RIMs BIAB system?

    good point but I could turn the pump off to grab a reading.
  3. C

    Anyone using a Tilt hydrometer with a RIMs BIAB system?

    They say the tilt is good to 185 degress F. I was wondering if anyone has tried using it in a RIMs Biab system? My thought is if you reach your target or are no longer gaining gravity points you can stop and start your boil. thoughts?
  4. C

    Yet another PID question.

    I see it now, I was looking at the td series manual. Mine is ta4-ssr so only OUR1 and AL2 supply DC power and AL1 is relay.
  5. C

    Yet another PID question.

    I am building a controller that will have two SSR(s) that control two different devices (heating element/heating element or heating element /cooling. I have a TA4-SSR (not -SNR or -RNR). My question is can I connect SSR(s) to either AL1 or AL2 do I need to provide dc power to pins 5 or 6? The...
See more
Back
Top