Recent content by Chuckdaddy

Not practical to replace the entire line. It's part of a trunk line that's running through walls. The potential for foaming was my concern. However, I think I'm going to try it near the keg since it is so much easier to do.

I need to add some restriction to one of my draft lines. It is simply pouring too fast. I have quarter inch line on that particular keg, and I need to choke it down. If I add some 3/16 beverage line, does it matter if I put the restriction on the keg side or does it have to be just before it...

I tackled this project yesterday. Actually found an even smaller chest freezer (2.1 cubic feet) for about $120. It works great. I ended up and used a plastic bucket for my reservoir. My temperatures have drastically reduced. I'm very happy with this solution. It's certainly much cheaper than...

Good point. Thanks.

Thanks for the reply. I thought about using a 5-10 gallon tub for the liquid as you mentioned, but my thinking was that I'd get better heat exchange by allowing the mix to go right up against the freezer wall. I suppose I could try the bucket and if it doesn't cool it enough that way, I...

I have a kegerator setup in my basement bar. The distance from the kegs to my tower is about 15 feet. The tower has four taps, so I'm using one of those "python" type lines from the kegerator to the tower that has 4 bev lines and a hot and cold chiller line. It is well insulated. The tower...