Recent content by Chuck Crowell

Sharing this as I have not seen info on this before, however, I didn’t search too hard. Found out that temps play a part in your BTUs and hard to get much from the standard 20 lbs propane tanks. See attached photos of temp/BTU chart. Most of the stands I’ve seen are not factoring in this or...

Thanks for sharing. Pumps have been previously bought/used so will use the cheap A to DC converter and the thermometer suggested. Much appreciated!

...or, found this gem on Amazon for converting AC to DC. Given the time I’ve spent looking for this #*!$ thermometer, I think I’m ready to splurge the $9 + thermometer suggested so I can put this piece of the project in the rear view mirror. Autek AC DC 15-52V Converter to DC 12V 2A Power...

I like this one a lot! Only issue I see is that it set up for DC voltage. As I see it, I need to have either 110 volt AC or 24 V AC. Converter/transformer is set up for conversion voltage, not DC. I wrote the seller to see if they had any of those in AC options.

any good leads on a Fahrenheit thermometer that uses pt100 sensor and can be panel mounted <$40? Can be 24v or 110v. Building a control box and wanting to run a straight up thermometer for the chill plate setup. I know I could use a PID or a thermostat but looking for clean setup.