Recent content by CCBrewer

Anything will do at this point

I'd be interested in 5 clamps and gaskets, pm me if you part it.

Looking for a bargain mill, With hopper would be nice but not a deal breaker. Three rollers preferred, but not a deal breaker. post here that you are pming me ;)

Congrats, great price

I would be interested in the faucets but I have no use for shanks

Good price, if I didn't have 3 pumps now... I would buy this.... Someone jump on this

I am interested in the shiner mlt. Pm me if still available, I am planning on driving up that way soon. Still available??

How much is steel up there? Those materials cost me a comparable $127, and I had about two ft left off of the 20ft sticks I bought. Brew stands run in the $260-$350 range. Since this is an inquiry post, I feel this Should be stated here. People should not pay for bad welds, any welder would...

If the buyer is prepaying the materials, $600 on top of materials is too damned high. Make a jig and sell that stand, better off that way, and only let them customize the height. So price could only change by a few $ for steel. If that is $600 on top of steel price..... Highway robbery. A...

U getting out or upgrading?

It is a solid aluminium 10 pass chill plate from a taprite ice box. Dimensions are ~28inX28in by 3-1/2" thick

Found a piece of bar equipment being scrapped due to the foam rotting and metal all fked up. After an hour, I was left with this, drain hole in center...... I am thinking inside my keezer and expand my taps with external tanks?? Please I need ideas.... Any ideas on worth besides scrap...

I'd be interested in the reducer, i already have a motor

I went with. 5 body chudnow regulator and have a 3 body nitro regulator... There are lots of setups for different people.

now there is a DIY I would have liked to have seen