Recent content by Carlscan26

Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Carlscan26

    Brewnique faucet

    I never did. If you do please report back :cheers:
  2. Carlscan26

    Show us your sculpture or brew rig

    I hate to tell you this but you shouldn’t use copper for a chiller in the fermenter - the low pH of the beer is going to strip copper into your beer. Switch that out for a SS coil and you’re good to go!
  3. Carlscan26

    Spike Conical- observations and best practices

    I’ve had the same problem on 3 out of 3 batches with the racking valve. I need to contact Spike about it.
  4. Carlscan26

    Ugh... tinny, sharp, tart, slimy wort after SSBT kettle upgrade

    Have you tried washing it with dish soap and warm water? Scrub out every port really well too.
  5. Carlscan26

    Win a Ss Brewtech Keg WaSsher!

    I’m in thanks!
  6. Carlscan26

    Show us your sculpture or brew rig

    Four switch your link is broken
  7. Carlscan26

    Show us your sculpture or brew rig

    Brewbuzzard, what did you use to control the solenoid?
  8. Carlscan26

    Spike Conical- observations and best practices

    Can I ask what your setup is with the Pump with regards to fittings and hoses etc?
  9. Carlscan26

    Spike Conical- observations and best practices

    Is anyone having issues with the spike cleaning ball working with a March pump? Mine will turn but doesn’t spray hard enough to get much of the top wet much less clean.
  10. Carlscan26

    Show us your sculpture or brew rig

    How many turns do you have from full closed to full open? Do they fall back a little when you adjust them or do they stay exactly where you put them(if that makes sense)?
  11. Carlscan26

    Doubling Down: SS Brewtech Conical + FTSS + Glycol Power Pack

    I originally posted that these were 3/8” barbs - they’re actually 1/2”. I’ve fixed the original post. I used these: https://www.brewhardware.com/product_p/fflbarb12.htm Bobby also sells a 3/8” barb version. Also it’s 3/8” hose onto these as I originally planned to use 1/2” hose all the way...
  12. Carlscan26

    Do you need a 1 off Stainless part built for your system? Let's discuss it.

    You can get different size barbs for the MFL fittings. I have used 1/2”, 5/16, 1/4 and 3/16
  13. Carlscan26

    My custom SS-topped single tier

    Nicely done! Where did you get those (needle?) gas valves? Do you have more than a 1/2 turn to control a low simmer? Do they “fall back” a bit when you adjust them?
Back
Top