• Please visit and share your knowledge at our sister communities:
    Cheesemaking Forum Cast Iron Forum Canning Forum Ceramic Grills
    Espresso Forum Hot Pepper Forums Pizza Oven Forums
  • If you have not, please join our official Homebrewing Facebook Group!

    Homebrewing Facebook Group

Recent content by Canuto

Yakima 728
Homebrew Talk

Help Support Homebrew Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. C

    STC1000+ 2nd probe causing alarm

    I checked the wiring which was OK but I wasn't getting an ohm reading when I checked across the two screw terminals for the 2nd probe. I re-soldered the screw post to the board which fixed the problem.
  2. C

    STC1000+ 2nd probe causing alarm

    I modified one of my STC1000 units to enable the 2nd probe. I soldered the micro resistor and added a 3 port post. I flashed with STC1000+ with the dual probe version. I connected a 2nd known-good probe to pin 4 and the new pin of the STC. When I enable the 2nd probe (Pb2 = 1) I immediately...
See more
Back
Top