Recent content by BruinsFan1975

Huge thanks to everyone in this thread for helping me out. I am back up and running with my beer flowing smoothly at a consistent temperature and the expected amount of head! Pictures of my new setup below! :tank: Inkbird Itc-308 Digital Temperature Controller (via the link that...

Thanks to everyone for the feedback and support! I have just ordered an Inkbird controller, a 120mm fan with 66 CFM and a tower cooler fan. Fingers crossed that these three things will fix the issue. They will be arriving tomorrow and I'll keep everyone posted as I install these and try it out!

That's a very good point. I am measuring the air temp right now, but I have also had my water bottles freeze in the fridge, so there is definitely something off. Would you recommend putting the temperature probe from the STC-1000 into a bottle of water?

Everything else has pretty much remained static, I think the challenge was that the beer was freezing due to the fridge swinging well below freezing temps (14 degrees F)

Would a tower cooler like this one (http://www.amazon.com/dp/B00OZPJ9X0/?tag=skimlinks_replacement-20) also circulate air within the mini fridge? Or would I need to buy two?

Reading more into this, is your suggestion to plug the entire kegerator as-is into the power outlet of the STC-1000? Or to rig something in line with the current temp controller?

That sounds brilliant! I see a lot of documentation on the STC-1000 online, would you be able to recommend any guide in specific?

Hi, I purchased a Nostalgia KRS2150 Kegorater about 3 years ago and recently I started having new problems with beer foam. After spending months troubleshooting my beer foam, I decided to purchase a wireless thermometer and to my surprise, the temperature varies from 14°F to 60°F where the knob...