Recent content by blmcga

Has anyone got the Grainfather Push Target to work?

@Thorrak can you point me in the right direction? my cooling cycle will come on for just a minute or 2, id like to avoid it and increase the idle time prior to cooling. I have no idea what Control Constrain i should be using to get this. See below. Also is there a way to remove the Heat/Cooling...

Ive got 3 Plaato Keg's if your looking for some testing with KegScreen...

Environment: Request Method: GET Request URL: http://192.x.x.x/api/gravity/ Django Version: 3.0.14 Python Version: 3.9.12 Installed Applications: ['django.contrib.admin', 'django.contrib.auth', 'django.contrib.contenttypes', 'django.contrib.sessions', 'django.contrib.messages'...

You can unattach it from http://192.168.x.x/gravity/sensor/x and it will be available from the Select Device to Control drop down again. I retried to attach it with the same outcome.

Same, after attaching iSpindel to my brewpi it disappears and then if i try to log i get no logging info. I can still get to the iSpindel via http://192.168.x.x/gravity/sensor/2/manage/ and it is still getting data.

OK, guess my WSL/Ubuntu that just doesn't like it? Using the semi-auto method admin@WSL:~/fermentrack-tools$ sudo ./install.sh ::: Checking for Internet connection: ::: Internet connection Success! ::: Verifying free disk space... ::: Sufficient free disk space is available ...

All good got 2 ESP8266's connected and they appear to be working fine. Will hook up to my fermenting fridge later and try to run a beer schedule to see how it does. Will Ubuntu 64 bit come down the pipe?

Got fermentrack up & working on Dietpi 64bit, can't get the ESP8266 to connect though... I had issues getting it to connect with 32 bit but it did finally connect, so i don't think its on fermentracks side.

I keep getting the bellow on my Rpi 3 B+ running Pi OS Lite (64 bit). Is fermentrack only 32 bit or am I doing something else wrong? Pulling django (jdbeeler/fermentrack:latest)... latest: Pulling from jdbeeler/fermentrack ERROR: no matching manifest for linux/arm64/v8 in the manifest list entries

Couple questions related to BPL. What versions of iSpindle are supported? What wifi do I connect to in ispindle? Brewpiless soft AP or router? How do I get the coefficients for BPL gravity setup? edit: got the coefficients by launching the calibrationSG.htm. Found router wifi needs to be use in...

Could use some input, got a new ESP8266 (HERE) and it looks to flash fine with Terminal, Arduino or even Nodemcu Flasher. When flashing with Terminal i don't see the Wifi for the board, when flashing with Arduino or Nodemcu Flasher the Wifi come up as ESP_XXXXX and the Wifi pop up doesn't...

@pocketmon is there a erase all/ reset cmd?

How can I reset the wifi settings?

Is pocketmon's brewpiless supported? Doesn't appear to be working.