Recent content by backwoodsdistiller

Ok, I see the Reference Resistor on the amplifier board. So, if I need to adjust the temperature to match the gold standard temperature, do I change the Linear multiplier value? Or the Reference Resistor value. I noticed on one of your post, I seen you set the Linear Multiplier to 1.0015.

BrunDog, Could you please explain your calibration setting for RTD's. How you obtained these numbers? Linear Multiplier: Linear Offset: Resistance Temperature: Thanks

If I upgrade the firmware to 1.5.0, do I need to recalibrate the levels and pressure?

@UncleD Congratulations on your new baby boy. Thank you for pointing out using the library.

Well, I got the Flite working. Here is what I did; I decided to test the distance sensor again from the cable connector to the sensors using the Arduino. The Arduino program would not run. So I disconnected the pressure sensor and sure enough, the distance sensor was working. I decided to take...

Thats ok, I really appreciate your help.

Ok, reflashed with BrewFlasher and erasing all data. Still not working. I did notice when I touch the screen, the blue LED on the WeMos will turn on. Another thing, when I tried to reflash the WeMos with the sensors connected, BrewFlasher will not connect to the WeMos. Also, the...

No, its not potted. I did check the distance sensor with an Arduino program and it works fine. I have no Arduino program to check the pressure sensor. I did disconnect the pressure sensor and only the distance in the circuit but still does not work. Yes, I traced the wires and they are correct.

Also notice that it will not get past the DNS Services Started with the sensors connected. With the sensors disconnected, the screen will go to ready.

LOL. Here are some pictures of the results using Putty. The first picture is with the sensors connected to the display. The second picture is with the sensors disconnected from the display.

Not sure what you mean; Derrick left Serial output?

Hello, I need some troubleshooting help. I'm using the display only. When the sensors are hooked to the display assembly, the display will freeze. With sensors unhooked, display works. What I mean by the display works is I get responses when touching the calibration buttons. I have checked the...