Recent content by Aydanrogers

Hi are any of these still available? How do they go with a Rpi4 in a fan case? Do you lose the ability to use the fans to cool the board? Cheers Aydos

Just for a little bit of feedback, I have been able to get it operational now. I'm not really sure how it is working as it isn't outputting a solid 12v when the unit is being run (rUn) in cO mode, it is only outputting around 2-3V but even when the unit isn't outputting then it still reads 2-3V...

Sorry I should have mentioned that I did set it to run mode (rUn) so it should have been outputting 12V. Both LED's were lit up showing that there should have been an output.

Yes I had the CO set to 200% so that both of the outputs should have had a reading since both LED's were lit up. I will try applying more solder this afternoon and if that doesn't work I will try to put the relays back on the board. I don't know how to test the pic so I might need to leave that...

Ok I'll elaborate a little as I didn't mention much in the original post. I took the relays off the board which were fully functioning before hand. I wired the point together as shown on the website with a bit of thin cable soldered to the board. I have continuity between each point on the board...

I have hit a bit of a wall with changing the unit to 12v output. I have left it with a 240v input but got the relays off the board and bridged it exactly the way that is shown in the wiki. We have continuity over each point but it's not outputting anything. What have I done wrong? Thank you

I am trying to wrap my head around covering the outputs to 12v so that I can wire it up to an ssr but I'm obviously not getting it completely. Do you desolder the entire relay off the board and wire up the 12v signal to the points or can you leave the relay there? Also how are you making the...

I understand that you can adjust how long the element is running for over the allocated time period but is there anyway to throttle the output of the element to something lower. Say turning the output down on a 2400W element to say around 1200W? Cheers

Is there anyway to change the output heat of the element with this setup at all or do you just have to set the % lower to around 10% or something? Lowering it just stops it turning on so often, is that right?

I had the probe placed in the return pipe from the pump but the issue was the wort under the grain bed heats up much faster than the remaining grain bed causing it to reach temp under the bed, cutting out the element and starting the rest timer. Once the wort runs through the mash bed it cools...

Hello, Im not sure if it has been answered in this thread or not but I am wondering if there was a way to get the mash schedule to operate so that it wont start the timer until it settles out at the correct temperature. My issue is I was running my STC 1000 OVBSC and I had the mash schedule...