Recent content by amandley

Hey, been a couple years since I've been active in this forum. And haven't brewed much over the past couple years either, truthfully. However, trying to get back into it. I'm stationed in Ponce, PR. Any info you have on sources or clubs or whatever would be rad.

Oh and I went with high pressure orifices and one main regulator at the tank. Each line has a needle valve and an orifice at the burner.

I swapped out valves with some needle valves and all is well. I still can't crank it all the way open but frankly, I wouldn't want to. These burners really rock! I brewed for the first time with the set up on this past Monday. Still need to iron out some of the process but overall a great...

Same size on the other. I hadn't seen a low pressure orifice so I wasn't sure how large it was.

Does this serve as a needle valve and an orifice? If so, how do I know if it's high pressure or low?

Palmer brewing in conjunction with left turn distilling.

Even without the keg on they blow themselves out

And after a first test run it took me right about an hour to boil 9 gallons

As the title states, I am having issues dialing in my new brew stand. I'm running high pressure bg 12. If I open up the regulator they blow themselves out. At lower settings I don't think I'm getting the type of flame wanted. About half blue half yellow.

The bottom of the keg was turning red? Did you have water in it? I definitely don't think that should be happenening

I normally let it sit in the keg carbing up for a week to two weeks depending on the beer. Seems like most higher Ibu beers take on the longer side of a week to really meld together and taste right

Yeah, just wasn't sure if that was overkill. Up to 350. I suppose it would work just fine tho. Thx

So, I bought some 5 ft hoses from Amazon that were described as high pressure. When they came in the mail, they were labeled high pressure but the stamp on the hoses says max 1 psi. Be aware of hoses that dont list a max psi in the description. I was able to return them so no big deal. What I...

Does anyone have any experience with these burners? http://www.agrisupply.com/carolina-cooker-replacement-burner/p/75679/ And as a side note, Is that "elbow fitting" the orifice? or do I still need to get an orifice?

Sorry, also, as far as the regulator goes. Ive seen where BG12's are said to be high pressure but on a few sites Ive seen them as low pressure. What regulator do I need to get? I really like the stuff on tejas smokers but its so damn expensive. I can pick up BG 12's for about 15$ each at the...