Recent content by AlwaysWaven

Man, you are knowledgeable and concise! Much thanks!

Ok, that is a lot of help and a great find on a cheaper distributor. http://www.ritebrew.com/product-p/843668.htm or https://www.kegconnection.com/air-distributor-6-way-with-check-valves/ So, do you recommend 1/4th hose or 3/16 hose?

Ok, this is a continuation from this thread - https://www.homebrewtalk.com/showthread.php?t=631566 Before I order the five way version of this - http://www.northernbrewer.com/4-way-co2-distributor-w-1-4-mfl-shutoffs Do I need 1/4th or 3/16 tubing? I think what is in there now is 1/4 but...

Ok, can do. I may have to replace a couple couplers - should I change those to the screw on type as well? Thank you

Hey everyone, I bought a keezer about 2 years ago and have loved it. Recently, I thought we were moving and so I tried to sell it :mad: Long story short, we are not moving and it is time to get to brewing. I have always had a problem with it leaking. I have tested various parts and think I...

I went back after I had cleaned things up and the ring that screws onto the backside of the faucet was really loose - is there a connection in there?

I made a batch of cherry cola tonight and all hell broke loose. I hooked it up, burped it a few times, and left it. I came back downstairs to find all 4 gallons on the floor and my CO2 tank empty. The tap was closed (or so I thought) but now everything is a mess. :mad: Thoughts? Both the...

I had issues tightening/loosening it. So, I should start with this - https://www.amazon.com/dp/B00GS15MPI/?tag=skimlinks_replacement-20 ?

Ok, I swapped the o-ring and heard the same noise. So, I sprayed it with soapy water and got this - The bubble seemed to be forming under the gray part of the disconnect. So, bad disconnect?

Clamped, I checked it and it is tight. It really sounds like it is coming from the plastic. I know I have both, so I will try the other one. It would have been nice if they came in different bags. :smack:

I bought a used keezer that is setup for 4 ball locks and one pin lock. I have gotten to the point that I need to use the pin lock. I filled the keg with sanitizer and water and hooked it up. Everything was fine but there was an audible leak from the air side. I unhooked it and checked the...

I just bought a used keezer and think my regulator is bad. When I bought the keezer it came with a 10lb bottle and regulator attached. Everyone who helped to move thought the tank still had C02 in it, but when we opened the valve no air came out of the regulator when we opened the line. So, I...

Thanks everyone! Last question - would the 310T be a better choice?

Thanks guys! Is the 308 my best bet? Is the probe included?

My wife wants a downstairs fridge for drinks. Not sure why but I may as well use it to my advantage. My thought is that if I add an inkbird 308 I can take the drinks out during fermentation and turn off the controller when it is just being used for drinks. I do not think heat will be a...