• Please visit and share your knowledge at our sister communities:
    Cheesemaking Forum Cast Iron Forum Canning Forum Ceramic Grills
    Espresso Forum Hot Pepper Forums Pizza Oven Forums
  • If you have not, please join our official Homebrewing Facebook Group!

    Homebrewing Facebook Group
Brewer's Friend 728
Homebrew Talk

Help Support Homebrew Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Holes drilled for the new valves. Just needed to make the bottom slightly large to accommodate the 1/2" fitting.
The inside of the kettle during a water test. I ended up using 90 degree elbows and barbed fittings for the intake and recirculation outlet.
The system on it's new stand with the kettle insulated and hooked up to the pump ready for a water test.
Holes drilled for the new valves. Just needed to make the bottom slightly large to accommodate the 1/2" fitting.
My first brew with the unit using the new controller. I brewed an Imperial Russian Stout.
The control circuits breadboarded out and connected to the Netduino Controller
lavinjj

Holes drilled for the new valves. Just needed to make the bottom slightly large to accommodate the 1/2" fitting.

Holes drilled for the new valves. Just needed to make the bottom slightly large to accommodate the 1/2" fitting.
Click to expand...
There are no comments to display.

Media information

Album
ElectricTurkeyFryerMod
Added by
lavinjj
Date added
View count
115
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top