Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Did a hatchet job with dremel cutting out center, gotta be careful doing this (bought clamps AFTER this job lol )

drilled through hole for CO2 line. IMPORTANT - I drilled from the inside first, (in case I ran into freon lines, the outside wouldnt look like swiss cheese as I hunted for a place without the lines) just going through the plastic and feeling around in the

attached board to shelf brackets for mounting 6way manifold

removed drawers and replaced with a shelf to give extra clearance for kegs and QC/hoses

placed couplings in, supported from fridge compartment and sprayed expanding foam insulation back in, be careful as the foam sticks to everything, you'll see later pics where the foam is still stuck to the pvc

fans placed in and just before wiring. Used the wiring for the light, took out the light switch and wired in the 2 fans

Did a hatchet job with dremel cutting out center, gotta be careful doing this (bought clamps AFTER this job lol )

krugvoll
Mar 6, 2010

There are no comments to display.