• Please visit and share your knowledge at our sister communities:
    Cheesemaking Forum Cast Iron Forum Canning Forum Ceramic Grills
    Espresso Forum Hot Pepper Forums Pizza Oven Forums
  • If you have not, please join our official Homebrewing Facebook Group!

    Homebrewing Facebook Group
SSBrew - 728
Homebrew Talk

Help Support Homebrew Talk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
And mocked up in the mash-tun (without false bottom for better picture) already tested with two batches and very successful.
And mocked up in the mash-tun (without false bottom for better picture) already tested with two batches and very successful.
Underneath shot of the Sparge Arm, can vaguely see the holes that required a trip to our local home improvement store for a drill press...
The new Stainless Sparge Arm thanks to our engineering half of our team! The tubing is actually 3/8 inch instead of half, had it on hand and with the low flow rates required for sparging we figured it would work just fine, and it does.
New pic of the system as it is now, and functional. Notice we had to turn the pump around and build a little shelf for it. I don't know much about pumps, but it did not work the other way around, someone mentioned rotating the head, but this works, so it
Pretty much finished with our 15" false bottom! Needs some finishing touches and some feet for support still.
pale_ale-froman

And mocked up in the mash-tun (without false bottom for better picture) already tested with two batches and very successful.

And mocked up in the mash-tun (without false bottom for better picture) already tested with two batches and very successful.
Click to expand...
There are no comments to display.

Media information

Album
TheBuild
Added by
pale_ale-froman
Date added
View count
117
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top