Stainless Steel 1/2" Barbed Elbow?

So, apparently there is no such thing as a Stainless Steel 1/2" NPT x 1/2" Barbed Elbow fitting. I have been searching the internet for about 3 days now and cannot find one. Basically, I need this fitting;



...but with a 1/2" barb (instead of 3/8").

I purchased the Bargainfittings.com cooler bulkhead kit with the optional female 1/2" hose barb for the inside fitting to connect to a false bottom. However, every false bottom I find has a 3/8" barbed elbow. I purchased the AIHB False Bottom without the fittings assuming I could put one together with a 1/2" barb. No such luck.

Looks likes I should have gone with a standard 1/2" coupler, and attached a 3/8" barb instead. The only other option I can think of is to use a 1/2" 90deg. Street elbow, and attach a 1/2" straight barb for the false bottom connection.

Any suggestions? Thanks in advance!

 

eBay My World - mainlandvf

email this guy, i got fittings like these a while back from him. he does not have any listed right now...as far as i could see. but he might have some.

 

Excellent! Thanks so much Bryan. Just ordered this one;
90* HOSE BARB 1/2" ID X 1/2" MPT HEX BREWING 316 <HB628 | eBay



I know most use the 3/8" barbed elbow in cooler mash tuns, but I had already ordered the 1/2" female barbed elbow with my bulkhead (without the coupler) inside the MT, hopefully allowing more clearance for the false bottom, and perhaps a slightly reduced flow rate under the FB due to the larger diameter tubing.

 

Blichmann has a series of 1/2" NPT fittings that might work. Check out their 90 degree elbow. Since it is female, you may need a hex nipple for it.
Blichmann Engineering

 

McMaster-Carr has them

http://www.mcmaster.com/#barbed-tube-fittings/=f2qvaj

search for part number 5670K19 pricey at $6.54 a piece + S&H but if you gotta have them.............

EDIT: I didn't read your post correctly - please ignor

 

How about a 90_deg street el?
You can force 1/2" silicone over the threads. My plan is to use them rather than barbed fittings for better flow.
You would need a nipple though.

 

Brew Hardware has these.

 

please check http://www.rajendrafittings.com/90_degree_elbow.html i think u will get what you want...

 

These are by far the best fittings on the market in my opinion.
They are 1/2" inside diameter and you have to stretch the hose over them, which is easily done.

 

If I need 80,000 90 degree elbows I'll give you a holla.